Test Setup - Test Configurator, Timer, and System
246 88000 Series
Local Details (iSAM)
VLAN ID/Priority check box when selected, cleared by default,
enables C-VLAN with VLAN Ethernet type of 8100 and allows setting
both VLAN ID and priority.
VLAN ID choices are 0 through 4095; default is 2; refer to VLAN ID and
Priority on page 842 for more information.
Priority choices are 0 (default) to 7. Refer to VLAN ID and Priority on
page 842 for more information.
IP
IP Version is set to IPv4.
Automatic IP (DHCP) check box, when selected (cleared by default),
allows obtaining dynamically an IP address from a DHCP (Dynamic
Host Configuration Protocol) server.
Note: IP Address, Subnet Mask, and Default Gateway are not available when
the Automatic IP (DHCP) check box is selected.
IP Address allows entering the source IP address for the stream. The
default setting is 10.10.x.y, where x and y are respectively the two least
significant bytes of the port default MAC address.
Subnet Mask allows entering the Subnet Mask for the stream. The
default setting is 255.255.0.0.
Default Gateway check box, when selected (cleared by default),
allows entering a default Gateway IP address. When the Default
Gateway check box is selected, its default address is 0.0.0.0.
Remote Discovery ID
Remote Discovery ID is used to easily identify this module in case another
module is performing a discovery scan. Up to 16 alpha-numeric characters
are allowed.
To Next Page
