Test Results
Power Blazer 425
Alarms/Errors Overview
Interface
Alarms
LOS (Loss Of Signal)
RX: Absence of an input signal or an all-zeros pattern is received.
Available for each Optical Lane for parallel interfaces. Not supported
when PHY Type is set to DAC.
For CPRI Framed L2:
For rates up to 9.8G: Absence of an input signal or at least 16
8B/10B code violations occur in one hyperframe.
For rate 10.1G: Absence of an input signal or the hi_ber variable is
set to true.
For Wander 1PPS interface: Either no pulse is received or no pulse is
received within 1 second ±100 ms after the previous pulse.
LOC Lane (Loss Of Clock Lane) is available for each Physical Lane for
parallel interfaces.
RX: The unit is unable to lock on the
Physical/CAUI/CAUI-4/XLAUI/200GAUI-4/400GAUI-8/16 link interface.
Frequency (available for each Physical Lane for parallel interfaces)
Not available when using an active copper SFP.
RX: The received signal frequency meets the standard specifications
(green) or not (red).
For Ethernet 100/1000M Electrical, 100M Optical, 1GE Optical,
10GE LAN/WAN, 25GE, or Fibre Channel 1X/2X/4X/8X/10X/16X/32X
interface/rate, the frequency range is ± 100 ppm. Not supported for
10M electrical.
To Next Page
Loading...
