VIII
CNC 8070
Version history
(SOFT V02.0X)
VIII
April 2005 Software: 2.03
Feature
New values of machine parameter SERPOWSE for the "Sercos II" board. INST
Independent-axis programming commands. INST
Electronic-cams programming commands. INST
New signals that may be consulted and changed for the independent interpolator
(electronic cam and independent axis)
INST
The simulated axes are ignored regarding the validation code.
When unifying parameters, G00FEED and MAXVOLT are not sent out to the drive. INST
Electronic-cam programming instructions (#CAM ON / #CAM OFF). PRG
Independent-axis programming instructions (#MOVE ABS / #MOVE ADD / #MOVE INF
/ #FOLLOW ON / #FOLLOW OFF).
PRG
G112. Change the drive’s parameter set . PRG
DDSSETUP mode OPT
G31. Temporary polar origin shift to the center of interpolation. PRG
To Next Page
Loading...
