Programming manual
CNC 8070
CYCLE EDITOR
Drilling 2.
12.
(SOFT V02.0X)
247
12.4 Drilling 2.
Geometric parameters:
Machining parameters:
Spindle turning direction (icon).
Clockwise with icon
(a)
and counterclockwise with icon
(b)
X, Y Machining point.
Z Part surface coordinate.
Zs Safety plane coordinate.
P Total depth.
I Penetration step. The drilling takes place with the given step,
except the last step that machines the rest.
B Relief distance (it withdraws), in rapid (G0), after each drilling
step.
F Feedrate.
S Spindle speed.
TTool.
D Tool offset.
t Dwell at the bottom, in seconds.
(b)(a)
To Next Page
Loading...
