Programming manual
326
CNC 8070
12.
CYCLE EDITOR
Boring 1.
(SOFT V02.0X)
254
Basic operation:
1. It starts the spindle in the requested direction.
2. Rapid movement (G0), up to the XY point and the safety plane (Zs).
Depending on the starting plane, it first moves in XY and then in
Z or vice versa.
3. Rapid movement (G0) up to the approach plane.
4. Penetration at feedrate "F".
5. Dwell "t".
6. If the icon
(b)
was defined, it stops the spindle (M05).
7. Withdrawal.
• If the icon
(a)
was defined, it first withdraws at feedrate "F" to the
approach plane (at 1 mm above the surface Z) and then in rapid
(G0) to the safety plane Zs.
• If the icon
(b)
was defined, it withdraws in rapid (G0) to the safety
plane Zs and then starts the spindle in the direction it was turning.
If it has a multiple machining operation associated with it, it executes
the following steps as often as necessary:
8. Rapid movement (G0) to the next point.
9. Repeats steps 3, 4, 5, 6, 7.
(b)(a)
To Next Page
Loading...
