Fagor CNC 8070 - Programs service



 Programming manual
CNC 8070
CYCLE EDITOR
Boring 2.
12.
(SOFT V02.0X)
255
12.8 Boring 2.
Geometric parameters:
Machining parameters:
Spindle turning direction (icon).
Clockwise with icon
(a)
and counterclockwise with icon
(b)
X, Y Machining point.
Z Part surface coordinate.
Zs Safety plane coordinate.
P Total depth.
β Spindle position, in degrees, for the withdrawal.
∆x, ∆y Distance the tool must move to get the cutter off the wall
before withdrawing.
F Feedrate.
S Spindle speed.
TTool.
D Tool offset.
t Dwell at the bottom, in seconds.
The following example shows how to use parameters β, ∆x and ∆y. The
spindle rest position (I0 position) is at -30º with respect to the X axis.
(b)(a)