Programming manual
326
CNC 8070
12.
CYCLE EDITOR
Boring 2.
(SOFT V02.0X)
256
Basic operation:
1. It starts the spindle in the requested direction.
2. Rapid movement (G0), up to the XY point and the safety plane (Zs).
Depending on the starting plane, it first moves in XY and then in
Z or vice versa.
3. Rapid movement (G0) up to the approach plane.
4. Penetration at feedrate "F".
5. Dwell "t".
6. The spindle stops and the tool is oriented in the "β" position (M19).
7. It gets the cutter off the wall. It moves the distance indicated by "∆x,
∆y".
8. Rapid withdrawal (G0) up to the approach plane.
9. The tool returns to its position (XY) and starts the spindle in the
direction it was turning.
10.Rapid movement (G0) up to the safety plane (Zs).
If it has a multiple machining operation associated with it, it executes
the following steps as often as necessary:
11.Rapid movement (G0) to the next point.
12.Repeats steps 3, 4, 5, 6, 7, 8, 9, 10.
To Next Page
Loading...
