Programming manual
CNC 8070
CYCLE EDITOR
2D pocket
12.
(SOFT V02.0X)
277
Spindle turning direction (icon).
Clockwise with icon
(c)
.
Counterclockwise with icon
(d)
.
Finishing parameters:
The finishing operation is carried out in two stages.
First, it machines the bottom of the pocket and then the side walls, with
tangential entry and exit.
The finishing operation defining parameters are:
β Penetrating angle.
The penetration is carried out maintaining this angle until the
corresponding depth is reached.
If defined with a value greater than the one assigned to the tool
in the tool table, it assumes the table value.
F Surface milling feedrate.
S Spindle speed.
T Roughing tool.
If programmed T=0, there is no roughing.
δ Finishing stock on the side walls.
δz Finishing stock at the bottom of the pocket.
(d)(c)
To Next Page
Loading...
