Programming manual
326
CNC 8070
12.
CYCLE EDITOR
2D pocket
(SOFT V02.0X)
278
Spindle turning direction (icon).
Clockwise with icon
(c)
.
Counterclockwise with icon
(d)
.
∆ Milling pass or width at the bottom of the pocket.
The cycle recalculates the pass so that all the passes are
identical, with the same value as or smaller than the one
programmed.
If programmed with a 0 value, it assumes a value of 3/4 of the
diameter of the selected tool.
N Number of penetration passes (steps) for the side finishing.
When programming a 0 value, it carries out the least amount
of passes possible, considering the cutting length assigned to
the tool in the tool table.
θ Penetrating angle.
The penetration is carried out at the feedrate set by roughing
parameter "Fz" maintaining this angle until reaching the
corresponding depth.
If defined with a value greater than the one assigned to the tool
in the tool table, it assumes the table value.
F Surface and side milling feedrate.
S Spindle speed.
T Finishing tool.
If programmed T=0, there is no finishing.
D Tool offset.
(d)(c)
To Next Page
Loading...
