Programming manual
CNC 8070
CYCLE EDITOR
3D pocket
12.
(SOFT V02.0X)
287
Spindle turning direction (icon).
Clockwise with icon
(a)
.
Counterclockwise with icon
(b)
.
Pre-finishing parameters:
This operation minimizes the ridges remaining on the side walls after
the roughing operation while maintaining the finishing stock δ.
I1 Penetration step.
• If programmed with a positive sign (I+), the cycle
recalculates the step so all the penetrations are identical
with the same value as or smaller than the one programmed.
• If programmed with a negative sign (I-), the pocket is
machined with the given pass (step) except the last pass
that machines the rest.
In either case, the cycle limits the step to the cutting length
assigned to the tool in the tool table.
Fz Penetration feedrate.
β Penetrating angle.
The penetration is carried out maintaining this angle until the
corresponding depth is reached.
If defined with a value greater than the one assigned to the tool
in the tool table, it assumes the table value.
F Surface milling feedrate.
S Spindle speed.
T Roughing tool.
If programmed T=0, there is no roughing.
D Tool offset.
(b)(a)
To Next Page
Loading...
