Programming manual
326
CNC 8070
12.
CYCLE EDITOR
3D pocket
(SOFT V02.0X)
288
The pre-finishing operation defining parameters are:
Spindle turning direction (icon).
Clockwise with icon
(a)
.
Counterclockwise with icon
(b)
.
Finishing parameters:
The finishing operation takes into account the geometry of the tool tip.
It compensates the tool tip radius defined in the table.
Machining direction for the side walls (icon).
Always down
(c)
, always up
(d)
, in zig-zag
(e)
.
Spindle turning direction (icon).
Clockwise with icon
(a)
.
Counterclockwise with icon
(b)
.
I2 Penetration step.
• If programmed with a positive sign (I+), the cycle
recalculates the step so all the penetrations are identical
with the same value as or smaller than the one programmed.
• If programmed with a negative sign (I-), the pocket is
machined with the given pass (step) except the last pass
that machines the rest.
In either case, the cycle limits the step to the cutting length
assigned to the tool in the tool table.
F Milling feedrate.
S Spindle speed.
T Pre-finishing tool.
If programmed T=0, there is no pre-finishing.
D Tool offset.
δ Finishing stock on the side walls.
ε Milling pass or width for the side walls.
F Milling feedrate.
S Spindle speed.
T Finishing tool.
If programmed T=0, there is no finishing.
D Tool offset.
(b)(a)
(d)(c)
(e)
(b)(a)
To Next Page
Loading...
