Programming manual
326
CNC 8070
12.
CYCLE EDITOR
Point-to-point profile
(SOFT V02.0X)
310
Finishing parameters:
In order to carry out the finishing operation, the roughing must be
defined with tool radius compensation.
The operation removes the finishing stock (δ).
The roughing operation defining parameters are:
Spindle turning direction (icon).
Clockwise with icon
(d)
.
Counterclockwise with icon
(e)
.
Basic operation:
1. It selects the roughing tool and starts the spindle in the requested
direction.
2. Rapid movement (G0), up to the XY point and the safety plane (Zs).
Depending on the starting plane, it first moves in XY and then in
Z or vice versa.
3. Rapid movement (G0) up to the approach plane.
4. Roughing operation.
It is carried out in layers until the total depth is reached.
4.1. Penetration "I" at feedrate "Fz".
4.2. Profile milling at feedrate "F" and tangential entry if it has
been programmed.
If it was defined with tool radius compensation, the milling
is carried out at a "δ" distance from the wall.
4.3. Exit to point XnYn with tangential exit if it has been
programmed.
4.4. Rapid withdrawal (G0) up to the safety plane (Zs).
δ Finishing stock on the side walls.
When working without tool radius compensation, there is no
finishing operation, the finishing stock (δ) is ignored.
F Milling feedrate.
S Spindle speed.
T Finishing tool.
If programmed T=0, there is no finishing.
D Tool offset.
(e)(d)
To Next Page
Loading...
