Fagor CNC 8070 - Page 467

To Next Page

To Previous Page







Programming manual

CNC 8070

STATEMENTS AND INSTRUCTIONS

Programming statements

15.

(SOFT V02.0X)

433

Screen display

At first, the axes appear ordered as they have been defined in the

general machine parameter table (by channels) and then as the

swapping is defined.

#CALL AX Adds an axis to the configuration

it adds one or more axes to the preset configuration and it also allows

defining its position. If the axis already exists in the configuration, it is

placed in the new position. Optionally, one or several offsets may be

applied to the defined axes.

The programming format is:

#CALL AX [<Xn>,<pos>...] <offset> <...>

Screen display of the different configurations. Let us suppose a machine

with 5 axes X-Y-Z-A-W.

00000.0000

#SET AX [Y, 0, 0, Z, A]

00125.1500

00089.5680

00000.0000

#SET AX [X, Y, Z] FIXOF ORGOF

Parameter Meaning

<Xn> Axes to be added to the configuration. If the axis

already exists, it is placed in the new position.

<pos> Optional. Position of the axis in the new

configuration. If not programmed, the axis is placed

after the last one. If the position is occupied, the

relevant error message will be issued.

<offset> Optional. It sets which offset is applied to the axes.

Several offsets may be applied.

#CALL AX [X,A]

(It adds the X and A axes to the configuration, after the last existing axis)

#CALL AX [V,4,C]

(It adds the V axis to position 4 and the C axis after the last one)

Other manuals for Fagor CNC 8070