Programming manual
486
CNC 8070
15.
STATEMENTS AND INSTRUCTIONS
Programming statements
(SOFT V02.0X)
434
Offset setting
The offsets that may be applied to the axes are identified with the
following commands. To apply several offsets, program the relevant
commands separated by a blank space.
Screen display
At first, the axes appear ordered as they have been defined in the
general machine parameter table (by channels) and then as the
swapping is defined.
#FREE AX Frees an axis from the configuration
Removes the programmed axes from the current configuration. After
removing an axis, the position is free, but the order of the axes that
remain in the channel does not change.
The programming format is:
#FREE AX [<Xn>,...]
Command Meaning
ALL Include all the offsets.
LOCOF Include the offset of the reference search.
FIXOF Include the fixture offset.
TOOLOF Include the tool offset.
ORGOF Include zero offset.
MEASOF Include measurement offset.
MANOF Include the offset of the manual operations.
#CALL AX [X] ALL
#CALL AX [V1,4,Y] ORGOF TOOLOF
Axis configuration
#SET AX [Y, 0, 0, Z]
Y: Abscissa axis.
Z: First auxiliary axis.
#CALL AX [X,2, W, 3]
Y: Abscissa axis.
X: Ordinate axis.
W: Axis perpendicular to the
plane.
Z: First auxiliary axis.
Y
X
W
Z
?
00000.0000
00000.0000
00000.0000
00000.0000
00000.0000
Parameter Meaning
<Xn> Axis to be removed from the configuration
#FREE AX [X,A]
(It removes the X and A axes from the configuration)
#FREE AX ALL
(Removes all the axes from the channel)
To Next Page
Loading...
