Programming manual
522
CNC 8070
16.
PROBING CANNED CYCLES.
Tool calibration
(SOFT V02.0X)
490
X, U, Y, V, Z, W
Optional parameters.
After ending the cycle
Once the calibration cycle has ended
It updates global arithmetic parameter P299 and the values assigned
to the tool offset selected in the tool table.
If the dimension of each edge was requested (parameter "N"), the
values will be assigned to global parameters P271 and the following
ones.
J Operation to be carried out.
Value Meaning
0 Tool calibration.
1 Wear measurement.
If not programmed, the canned cycle will take the value of "J0".
F Probing feedrate.
L Maximum length wear allowed.
If not programmed, the cycle assumes the value "L0" (the tool
will not be rejected due to length wear).
D Radius or distance referred to the tool shaft where it is probed.
If not programmed, the cycle assumes the tool radius value.
S Tool direction and turning speed. The chosen direction must
be opposite to the cutting direction (Positive if M3 and negative
if M4).
If not programmed, the cycle assumes the value "S0"
(calibration with spindle stopped).
C Behavior when exceeding the maximum wear allowed.
Value Meaning
0 It shows a message of rejected tool and stops the cycle.
1 The cycle replaces the tool with another one of the same
family.
If not programmed, the canned cycle will take the value of "C0".
N Number of cutting edges to be measured; The "S" parameter
must be defined with a value other than zero.
If not programmed, the cycle assumes the value "N0" (one
single measurement).
P299 (Measured length) - (previous length (L+LW)).
L Measured length.
LW 0
To Next Page
Loading...
