Programming manual
522
CNC 8070
16.
PROBING CANNED CYCLES.
Outside corner measuring canned cycle
(SOFT V02.0X)
506
4. Second approach movement.
Rapid probe move (G00) from the first approach point to the
second.
This approach movement is made in two stages:
·1· Movement along the ordinate axis.
·2· Movement along the abscissa axis.
5. Second probing movement.
Probing movement along the ordinate axis at the indicated
feedrate (F) until the probe signal is received.
The maximum probing distance is 2B. If once this distance has
been reached, the CNC has not yet received the probe signal, it
will issue the relevant error code and stop the movement of the
axes.
6. Withdrawal movement.
Rapid probe movement (G00) from the second probing point to the
cycle calling point.
The withdrawal movement is made in three stages:
·1· Movement to the second approach point along the probing axis.
·2· Movement along the longitudinal axis up to the coordinate of the
cycle calling point along that axis.
·3· Movement in the main work plane up to the cycle calling point.
To Next Page
Loading...
