Programming manual
522
CNC 8070
16.
PROBING CANNED CYCLES.
Hole measuring canned cycle
(SOFT V02.0X)
518
2. Probing movement.
This movement consists of:
·1· Probing movement along the ordinate axis at the indicated
feedrate (H) until the probe signal is received.
The maximum probing distance is "B+(J/2)". If once this
distance has been reached, the CNC has not yet received the
probe signal, it will issue the relevant error code and stop the
movement of the axes.
·2· Probe's rapid withdrawal (G00) the distance indicated by (E).
·3· Probing movement along the ordinate axis at the indicated
feedrate (F) until the probe signal is received.
3. Withdrawal movement.
Rapid probe movement (G00) from the probing point to the
theoretical center of the hole.
4. Second probing movement.
It is similar to the previous one.
5. Withdrawal movement.
Rapid probe movement (G00) from the probing point to the real
center of the hole (calculated) along the ordinate axis.
6. Third probing movement.
It is similar to the previous ones.
7. Withdrawal movement.
Rapid probe movement (G00) from the probing point to the
theoretical center of the hole.
8. Fourth probing movement.
It is similar to the previous ones.
9. Withdrawal movement.
Rapid probe movement (G00) from the probing point to the real
center (calculated) of the hole.
When programming (C0), the probe moves to the cycle calling
point.
·1· Movement along the longitudinal axis up to the coordinate of the
cycle calling point along that axis.
·2· Movement in the main work plane up to the cycle calling point.
To Next Page
Loading...
