Programming manual
522
CNC 8070
16.
PROBING CANNED CYCLES.
Boss measuring canned cycle
(SOFT V02.0X)
520
Result of the measurement
Once the cycle has ended, the CNC returns the real values obtained
in the measurement to the following general arithmetic parameters:
Basic operation
1. Positioning over the boss center.
Rapid probe movement (G00) from the cycle calling point to the
center of the boss.
The approach movement is made in two stages:
·1· Movement in the main work plane.
·2· Movement along the longitudinal axis up to a (B) distance from
the programmed surface.
2. Movement to the first approach point.
This probe movement is made in rapid (G00) and consists of:
·1· Movement along the ordinate axis.
·2· Movement of the longitudinal axis a (2B) distance.
3. Probing movement.
F Probing feedrate.
P294 Boss diameter.
P295 Boss diameter error. Difference between the real and the
programmed diameters.
P296 Real center coordinate along the abscissa axis
P297 Real center coordinate along the ordinate axis.
P298 Error detected along the abscissa axis. Difference between
the actual center coordinate and the programmed
theoretical coordinate.
P299 Error detected along the ordinate axis. Difference between
the actual center coordinate and the programmed
theoretical coordinate.
To Next Page
Loading...
