Programming manual
CNC 8070
PROBING CANNED CYCLES.
Boss measuring canned cycle
16.
(SOFT V02.0X)
521
This probing movement is made in three stages:
·1· Probing movement along the ordinate axis at the indicated
feedrate (H) until the probe signal is received.
The maximum probing distance is "B+(J/2)". If once this
distance has been reached, the CNC has not yet received the
probe signal, it will issue the relevant error code and stop the
movement of the axes.
·2· Rapid probe withdrawal (G00) the distance indicated in (E).
·3· Probing movement along the ordinate axis at the indicated
feedrate (F) until the probe signal is received.
4. Movement to the second approach point.
Rapid probe movement (G00) from the probing point to the next
approach point.
The movement is carried out in two stages.
·1· Withdrawal to the first approach point.
·2· Movement a (B) distance over the boss up to the second
approach point.
5. Second probing movement.
Same as the first probing movement.
6. Movement to the third approach point.
It is similar to the previous one.
7. Third probing movement.
It is similar to the previous ones.
8. Movement to the fourth approach point.
It is similar to the previous ones.
9. Fourth probing movement.
It is similar to the previous ones.
10.Withdrawal movement.
The withdrawal movement is made in three stages:
·1· Withdrawal to the fourth approach point.
·2· Rapid probe withdrawal (G00) at a (B) distance over the boss
up to the (calculated) real boss center.
·3· When programming (C0), the probe moves to the cycle calling
point.
It first moves along the longitudinal axis to the coordinate
corresponding to this axis of the cycle calling point and, then
it moves in the main work plane to the cycle calling point.
To Next Page
Loading...
