Fagor CNC 8070 - Page 7

Hardware configuration.
CNC 8070
·7·
(REF: 1911)
CHAPTER 17 INSTALLING AND CONFIGURING A THIN CLIENT (EPATEC MODEL).
17.1 Install and configure the communication software at the CNC. ................................... 265
17.2 Configuring the Thin Client. ......................................................................................... 267
17.2.1 Configure the network protocol (for network or point-to point connection)............... 267
17.2.2 Configure the communication between the CNC and the Thin Client...................... 268
17.2.3 Configuring the startup of the Thin Client................................................................. 269
17.2.4 Disable the mouse at the Thin Client. ...................................................................... 270
CHAPTER 18 INSTALLING A SENSOR FOR GAP CONTROL (LASER MODEL).