RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP 800 Series Card Printer/Encoders Service Manual (Rev. 5.0)
107
Resolving the Lamination (not adhering to the card surface) problem (cont.)
Step Procedure
2 Check the Lamination Temperature.
a. Open the Printer Control Panel from the Computer.
• If using Windows 98Se/ME, right click on the HDP800 Series-LC
Card Printer Icon and select Properties.
• If using Windows NT 4.0, right click on the HDP800 Series-LC Card
Printer and select Document Defaults.
• If using Windows 2000/XP, right click on the HDP800 Series-LC
Card Printer and select Printing Preferences.
b. Click on the Lamination tab.
c. Increase the Lamination Temperature by +5 degrees.
d. Click on the OK button.
e. Print and Laminate a card from the software.
f. Continue to adjust the Lamination Temperature until the Lamination
adheres completely and cannot be peeled off.
g. Adjust (as needed) the card flattener if increased temperature is causing
the cards to bow.
To Next Page
Loading...
