RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP 800 Series Card Printer/Encoders Service Manual (Rev. 5.0)
41
Reviewing the Cancel button
Component Description Reference
Cancel
Button
The Cancel button serves to cancel the
current Lamination job and reset the Card
Lamination Module for the next Lamination
job.
• If a card is left within the Lamination
Module after a print job is canceled, it will
automatically be ejected into the
Rejection Card Hopper. (Note: With the
Lamination Module's Transfer Station
open, this button can also be used to
manually rotate the feed rollers forward.
This is helpful when cleaning the rollers
or if clearing jammed media.)
• If you are printing and
laminating
simultaneously and you would like to
cancel both the print and Lamination
jobs, press the Printer's CANCEL
softkey button. (Note: This will cancel all
jobs in the Printer. Any card currently
laminating will finish and eject. The
Lamination Module's Cancel button
cancels only the Lamination job.)
See the Using the
Lamination tab (only with
the Card Lamination
Module) in Section 5, page
238.
Continued on the next page
To Next Page
Loading...
