FARGO electronics HDP820 - Section 3: Card Lamination Module; Safety Messages (review carefully)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP 800 Series Card Printer/Encoders Service Manual (Rev. 5.0)
122
Resolving an incomplete transfer on the leading edge problem
Symptom: If incomplete transfer is limited to the leading edge, the Transfer Tension is set
too high.
Step Procedure
1
Decrease the Transfer Tension through the LCD.
a. Select the Menu from the LCD
b. Select the Setup Printer and then select Transfer Tension.
c. In increments of one, decrease the Transfer Tension through the LCD Setup
Menu and print a card.
Resolving an incomplete transfer on the trailing edge problem
Symptom: If incomplete transfer is limited to the trailing edge, the Transfer Tension is set
too low.
Step Procedure
1
Increase the Transfer Tension through the LCD
a. Select Menu from the LCD.
b. Select Setup Printer and then select Transfer Tension.
c. In increments of one, increase the Transfer Tension through the LCD Setup
Menu and print a card.