FARGO electronics HDP820 User Manual

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP 800 Series Card Printer/Encoders Service Manual (Rev. 5.0)
47
Reviewing the Laminator Temperature Adjustment
Term Description Reference
Laminator
Temperature
Adjustment
To change the temperature of the
Laminator, adjust its temperature through
the Lamination tab within the Printer
Driver setup window.
• New Temperature Settings: Once
adjusted, the new temperature
settings will be sent down with the
next print job along with the rest of the
Printer Driver information. Before
printing begins, the laminator will
automatically adjust itself to the new
temperature setting. (Note: This new
temperature setting will remain
programmed within the Printer until it
is once again changed within the
Printer Driver or until the Printer is
turned OFF.)
• Automatic Reset: Whenever the
Printer is turned OFF, the laminator
will automatically reset itself and
return to its default temperature the
next time the Printer is turned ON.
(Note: Pressing the Lamination
Module's or Printer's Cancel button or
switching the Printer power OFF and
ON both serve to reset the Laminator
to its default temperature.)
• Consistent Temperature: The
temperature setting within the Printer
Driver stays the same until it is
changed.
See the Using the Lamination
tab (only with the Card
Lamination Module) in Section
5, page 238.

FARGO electronics HDP820 Specifications

General

Brand	FARGO electronics
Model	HDP820
Category	Printer
Language	English