RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP 800 Series Card Printer/Encoders Service Manual (Rev. 5.0)
461
Changing the Encoder Settings
Make this selection to modify the Encoder settings. These settings would need to be
changed (a) if the Print Board is replaced or (b) if the Printer is upgraded to include an
Encoder.
• Mag: None or Installed.
• Smart: None or Installed.
• Prox: None or Installed.
Step Procedure
1
Select MENU, Setup Printer and Encoder Settings.
2 Change the desired option as needed.
Example: Adding a Mag Encoder change MAG from None to Installed.
3
Press SELECT to save the value.
To Next Page
Loading...
