RESTRICTED USE ONLY Fargo Electronics, Inc.
HDPī 800 Series Card Printer/Encoders Service Manual (Rev. 5.0)
136
Section 3: Card Lamination Module
The purpose of this section is to provide the User with specific information on Printer
adjustment procedures.
Safety Messages (review carefully)
Symbol Critical Instructions for Safety purposes
Danger: Failure to follow these installation guidelines can result in death or
serious injury.
Information that raises potential safety issues is indicated by a warning
symbol (as shown to the below).
ā¢ To prevent personal injury, refer to the following safety messages
before performing an operation preceded by this symbol.
ā¢ To prevent personal injury, always remove the power cord prior to
performing repair procedures, unless otherwise specified.
ā¢ To prevent personal injury, make sure only qualified personnel
perform these procedures.
Caution: This device is electrostatically sensitive. It may be damaged if
exposed to static electricity discharges.
Information that raises potential electrostatic safety issues is indicated by a
warning symbol (as shown to the below).
ā¢ To prevent equipment or media damage, refer to the following safety
messages before performing an operation preceded by this symbol.
ā¢ To prevent equipment or media damage, observe all established
Electrostatic Discharge (ESD) procedures while handling cables in or
near the Circuit Board and Printhead Assemblies.
ā¢ To prevent equipment or media damage, always wear an appropriate
personal grounding device (e.g., a high quality wrist strap grounded to
avoid potential damage).
ā¢ To prevent equipment or media damage, always remove the Ribbon
and Cards from the Printer before making any repairs, unless otherwise
specified.
ā¢ To prevent equipment or media damage, take jewelry off of fingers
and hands, as well as thoroughly clean hands to remove oil and debris
before working on the Printer.
To Next Page
Loading...
Need help?
General
