RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP 800 Series Card Printer/Encoders Service Manual (Rev. 5.0)
152
Attaching the Card Lamination Module
The Card Lamination Module can be attached as a field upgradeable option. (Note: This can
typically be done in 30 minutes or less and with no other tools than a Phillips screw Driver.)
This section applies only if you are installing the field upgradeable Card Lamination Module
onto a Printer. (Note: The Printer model must be capable of accepting this Module as not all
Printer models are compatible with this field upgradeable option. HDP800 Series Printers
with a serial number greater than A2360028 are compatible with the Card Lamination
Module.)
Step Procedure
1 Remove the Card Lamination Module from its packaging.
2 Disconnect the power cable from the Printer.
3
Open the Printer's Print Station and Transfer Station. (Note: Leave these
open for the entire procedure until you are instructed to close them.)
Continued on the next page
To Next Page
Loading...
