RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP 800 Series Card Printer/Encoders Service Manual (Rev. 5.0)
198
Using the Link Card to Print Job option
Use this option to link a specific card to a specific print job. Generally this option is used
mostly when printing and encoding e-cards. (Note: In this case, it is often critical that an e-
card with a pre-encoded serial number, for example, coincide with a particular printed image.
If the two were to get out of sync, the card's security could be compromised.)
Step Procedure
1 Select this option to cause the Printer to dispense with the print job if a blank
card is removed or ejected. (Note: The next card is then fed into the Printer and
the next coinciding print job then printed.)
To Next Page
Loading...
