RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP 800 Series Card Printer/Encoders Service Manual (Rev. 5.0)
120
Resolving the HDP Film wrinkle problems (continued)
Step Procedure
4 Adjust the Film Tension.
a. Select Menu from the LCD.
b. Select Setup Printer and then select Film Tension.
c. In increments of one, lower the Film Tension through the LCD Setup Menu
and print a card.
• If (after several adjustments) the film wrinkle appears worse, return the
Film Tension to its original setting and adjust the Film Tension up at
increments of one.
• If there is still no change after the fourth adjustment (after having made
changes to the Film Tension by a total of 4 points), go back to the original
Film Tension value.
d. Lower the Film Drive by one (1) increment and repeat Steps a. to c. (above)
until the film wrinkle is alleviated.
To Next Page
Loading...
