RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP 800 Series Card Printer/Encoders Service Manual (Rev. 5.0)
469
Firmware Updater Application Program (continued)
Step Procedure
2
Click on OK when prompted to Save this Program to Disk and then select a
folder in which to save the Updater file.
3 a. Once the file has been downloaded, navigate to the location where the file
was saved. The Firmware Updater program has been compressed for ease
of downloading.
b. Decompress the file by double-clicking on the UPDATER.EXE icon.
4 Double-click on the SETUP.EXE file to launch the Firmware Updater Setup
Program
5 Follow the on-screen instructions to complete installation. Once installed, the
Firmware Updater icon will appear in the Start/Programs/Fargo folder.
6 Select the Firmware Updater icon displayed below to open the Firmware Updater
application program.
To Next Page
Loading...
