FARO
®
Laser Scanner Manual
115
Chapter 8: Special Scanning Modes
On the Scanner Configure the scanner
1. Configure the WLAN connection on the laser scanner. (See
WLAN on
page 91
.)
2. Configure scan project/cluster, scan name, scan parameters.
Enable On-Site Registration
1. Open
Home > Manage > On-Site Registration Settings.
2. Turn On-site Registration ON by sliding the button. The scanner now
connects to a remote system in the network, running SCENE.
On your Computer Configure SCENE
1. Configure the WLAN network of the computer.
2. Start SCENE on the computer.
3. Start On-Site Registration task in the Scanning category of SCENE.
4. Enter the IP address of the laser scanner. You can find the IP address of
the laser scanner by tapping Manage > General Settings > WLAN > IP
Address on the scanner user interface. Enter the IP address as it is,
following exactly the given scheme of digits.
5. Connect to the FARO laser scanner after entering the IP address in the
On-Site Registration task. The scanner Home page is displayed. Note the
change in the available buttons at the bottom of the screen: instead of the
Scans button, the Map button appears.
6. On the scanner home page click the Map button. A map is displayed with
the available scans in a project.
The scanner and computer must be continuously connected to
the same WLAN network.
To Next Page
Loading...
