Fimer PVS980-58 - Ambient Conditions and Material Specifications

Technical data 111
Ambient conditions
Environmental limits for the inverter are given below. The inverter is designed
for outdoor environment.
Operation
installed for stationary
use
Storage
in the protective package
Transportation
in the protective package
Installation site altitude 0 to 4000 m (13123 ft)
Above 1000 m (3281 ft),
see section Altitude
derating on page 96.
- -
Air temperature -20 to +60 °C
(-4 to 140 °F)
With option C203:
-40 °C…+60 °C
(-40 °F…+122 °F)
Refer to Temperature
derating on page 95.
-40 to +70 °C
(-40 to +158 °F)
-40 to +70 °C
(-40 to +158 °F)
Relative humidity 4% to 100% Recommended
maximum 95%
Recommended
maximum 95%
Condensation allowed. Maximum allowed relative humidity is 60% in the
presence of corrosive gases.
Environmental category Outdoor (not air conditioned)
Wet conditions Allowed
Pollution degree 3 (2 inside the cabinet except for the Main and LCL air channel)
Contamination levels
(IEC 60721-3-3,
IEC 60721-3-2,
IEC 60721-3-1)
No conductive dust allowed.
Chemical gases:
Class 3C3
Solid particles:
Class 3S4
Chemical gases:
Class 1C2
Solid particles:
Class 1S3
Chemical gases:
Class 2C3
Solid particles:
Class 2S4
Corrosion class (ISO 9223) C4 (C5 optional) C4 (C5 optional) C4 (C5 optional)
Atmospheric pressure 70 to 106 kPa
0.7 to 1.05 atmospheres
70 to 106 kPa
0.7 to 1.05 atmospheres
60 to 106 kPa
0.6 to 1.05 atmospheres
Vibration (IEC 60068-2) Max. 1 mm (0.04 in)
(5 to 13.2 Hz),
max. 7 m/s
2
(23 ft/s
2
)
(13.2 to 100 Hz)
sinusoidal
Max. 1 mm (0.04 in)
(5 to 13.2 Hz),
max. 7 m/s
2
(23 ft/s
2
)
(13.2 to 100 Hz)
sinusoidal
Max. 3.5 mm (0.14 in)
(2 to 9 Hz),
max. 15 m/s
2
(49 ft/s
2
)
(9 to 200 Hz) sinusoidal
Shock (IEC 60068-2-27) Not allowed Max. 100 m/s
2
(330 ft/s
2
), 11 ms
Max. 100 m/s
2
(330 ft/s
2
), 11 ms
Free fall Not allowed Not allowed Not allowed