Technical data 115
CE mark
A CE mark is attached to the inverter to indicate compliance with the provisions of the
European Low Voltage and EMC Directives.
Compliance with the European Low Voltage Directive
The compliance with the European Low Voltage Directive has been assessed according to
standards IEC/EN 62109-1 and IEC/EN 62109-2.
Compliance with the European EMC directive
The EMC Directive defines the requirements for immunity and emissions of electrical
equipment used within the European Union. EMC standards IEC/EN 61000-6-2 and
EN55011 cover requirements stated for electrical and electronic apparatus intended for
use in industrial environments. In addition, the IEC/EN 61000-6-4 standard can be fulfilled
as an option (+E203).
Compliance with international EMC standards
• IEC/EN 61000-6-2
• EN 55011
• CISPR 11
• IEC/EN 61000-6-4 as an option (+E203)
UL mark
The inverters are UL listed with the applicable option (+C129).
RCM mark
The RCM marking is required in Australia and New Zealand. An RCM mark is attached to
the inverter to indicate compliance with the relevant standards IEC/EN 61000-6-2 and
CISPR 11, mandated by the Trans-Tasman Electromagnetic Compatibility Scheme. In
addition, the IEC/EN 61000-6-4 standard can be fulfilled as an option (+E203).
To Next Page
Loading...
