Easy Routing Splitscreen Restrictions
The C-MAP
®
Easy Routing feature is available on all
Raymarine LightHouse
TM
powered MFDs. However
some MFD variants are restricted to displaying in a
single page application only when using this feature.
Fullscreen / Splitscreen Fullscreen only
eS Series All variants
a6x
gS Series All variants
a7x
c12x a9x
e12x c9x
e165
e7 / e7D
a12x
Building a route using automatic route
generation
Automatic route generation can be used to create an
entire route or can be activated at any time when
building a new route.
From the Chart application:
1. Select Build Route from the chart context menu
or the Navigate menu.
The Build Route menu is displayed.
2. Select Autorouting, Dock-to-dock Autorouting
or Easy Routing so that On is selected.
Automatic route generation can be switched On
and Off at any time during route building.
3. Select the position on the Chart where you want
the route or route leg to start.
4. Select the position on the Chart where you want
the route or route leg to end.
The system will try to automatically calculate the
shortest safe route between the 2 points.
If the automatic route generation completes
successfully the calculated route is displayed.
Waypoints within the route that were calculated
using automatic route generation are assigned
the Marker waypoint symbol.
5. Subsequent route legs can be added by selecting
the next desired location on the Chart.
6. When your route is complete select Finish Build.
The Finish Route Build warning is displayed.
7. Select Exit to complete the route and close the
Build Route menu.
8. Select Follow to immediately start following the
generated route.
9. Select Edit to display the Route in the Route List
Waypoints, Routes and Tracks
155
To Next Page
Loading...