Section 8: Model 9500B — Routine Maintenance and Test 8-1
Final Width = 215mm
Section 8 Model 9500B — Routine Maintenance and Test
Section 8 gives first-level procedures for maintaining a Model 9500B, performing the Selftest operations and dealing with their results. We shall
recommend maintenance intervals, methods and parts, and detail the routine maintenance procedures. Section 8 is divided into the following sub-
sections:
8.1 About Section 8
8.2 Routine Maintenance.
8.2.1 General Cleaning ............................................... 8-2
8.2.2 Air Intake Filter — Description and Maintenance
Intervals ............................................................. 8-2
8.2.2.1 Removing the Top Cover ................... 8-2
8.2.2.2 Top Guard Shield and Calibration Seal
— Caution! ....................................... 8-2
8.2.2.3 Removing the Filter Element ............. 8-2
8.2.2.4 Cleaning the Filter Element ............... 8-2
8.2.2.5 Refitting the Filter Element ................ 8-2
8.2.2.6 Refitting the Top Cover ...................... 8-2
8.2.2.7 Replacement Parts ............................ 8-2
8.2.3 Firmware Upgrade ............................................. 8-3
8.2.3.1 Introduction ....................................... 8-3
8.2.3.2 Procedure ......................................... 8-3
8.3 Model 9500B Test and Selftest
8.3.1 Types of Test ..................................................... 8-4
8.3.1.1 Entry to Test Mode ............................ 8-4
8.3.2 Base, Heads, All and Fast Selftests .................... 8-4
8.3.2.1 Aborting the Selftest .......................... 8-4
8.3.2.2 Selftest Runs to Completion .............. 8-5
8.3.2.3 Viewing the Test Results ................... 8-5
8.3.2.4 Printing the Test Results ................... 8-5
8.3.3 Selftest at Power-On .......................................... 8-6
8.3.4 Interface Test ..................................................... 8-6
8.3.4.1 Access to Interface Tests. .................. 8-6
8.3.4.2 Display Memory Checks ................... 8-6
8.3.4.3 Keyboard Checks .............................. 8-7
8.3.4.4 Display Checks ................................. 8-7
8.3.4.5 Memory Card Checks ....................... 8-8
8.3.4.6 Tracker Ball Checks .......................... 8-9
8.3.4.7 Printer Checks ................................... 8-9
8.4 Printing Selftest Results
8.4.1 Introduction ..................................................... 8-10
8.4.2 Parallel Port ..................................................... 8-10
8.4.3 Printing Setup ................................................. 8-11
8.4.3.1 Printer Type ..................................... 8-11
8.4.3.2 Data Formatting ............................... 8-11
8.4.4 Results Printout ............................................... 8-11
Appendix A: Error Reporting Subsystem.
To Next Page
