Fluke 9500B - Page 249

Section 10: Calibrating the Model 9500B: Calibration Mode 10.3-1
Final Width = 215mm
10.3 The Model 9500B Calibration Mode
10.3.1 Introduction
This section is a guide to the use of the Model 9500B's Calibration Mode, for manual calibration of the 9500B Mainframe. The following topics
are covered:
10.3.2 Mode Selection
10.3.2.1 'Mode' Key
10.3.2.2 'Mode Selection' Screen
10.3.3 Selection of Calibration Mode
10.3.3.1 Calibration Enable Switch
10.3.3.2 Password
10.3.3.3 Calibration Mode Display
10.3.3.4 Calibration Mode Screen Softkeys
10.3.4 Special Calibration
10.3.4.1 Selecting Special Calibration
10.3.4.2 When to Characterise
10.3.4.3 How to Characterise
10.3.4.4 Form of Characterisation
10.3.5 Special Cal: 'Adjust FREQ'
10.3.5.1 When to Adjust
10.3.5.2 Equipment Requirements
10.3.5.3 Interconnections
10.3.5.4 9500B and Counter Setup
10.3.5.5 Sequence of Operations
10.3.6 Mainframe Standard Calibration (STD CAL)
10.3.6.1 Function Selection
10.3.6.2 Cal Mode Function Screens
10.3.6.3 'Hardware Configurations'
10.3.6.4 'Target Calibration Values'
10.3.7 Overview of Calibration Operations