Fluke DTX Series - Installing and Removing Fiber Modules; Verifying Operation

DTX Series CableAnalyzer
Technical Reference Handbook
5-4
Installing and Removing Fiber Modules
Figure 5-2 shows how to install and remove the fiber
modules.
Caution
Leave the module bay covers in place when the
fiber modules are not installed.
Caution
Turn off the tester
before attaching or
removing modules.
amd34af.eps
Figure 5-2. Installing and Removing Fiber Modules
Verifying Operation
1 Clean the tester’s connectors and the connectors on
two SC/SC patch cords.
2 Connect the tester and smart remote together, as
shown in Figure 5-1.
3 Turn the rotary switch to SPECIAL FUNCTIONS.
4 Use
D to highlight Self Test; then press H.
5 Press
Pto start the self test.
TALK
MONITOR
ENTER
TEST
SAVE
SPECIAL
FUNCTIONS
SETUP
AUTO
TEST
SINGLE
TEST
EXIT
F1 F2 F3
TALK
TEST
PASS
TEST
FAIL
TALK
TONE
SC to SC patch cords
amd118f.eps
Figure 5-3. Self Test Connections for Fiber Modules