Fluke DTX Series - Step 8: Saving the Results; Using the Auto Increment and Sequential Cable ID Features; Using the Auto Increment Feature

DTX Series CableAnalyzer
Technical Reference Handbook
2-20
Step 8: Saving the Results
8-1 Press N.
8-2 Use the text editing screen to enter a name for the
results. See Figure 2-1 on page 2-3 for details on
editing text.
8-3 Press
N when you are done.
This concludes the tutorial on testing fiber cabling. For
more information on testing fiber cabling, see Chapter 5.
Using the Auto Increment and
Sequential Cable ID Features
The auto increment and sequential ID features generate
cable IDs automatically. This frees you from having to
enter IDs manually after each test.
These features are useful when you test installations with
sequentially-numbered links.
When you use an ID from a list, the ID is marked with a
“$”.
Note
The List feature lets you select IDs from a list
created with LinkWare software and
downloaded to the tester. See the LinkWare
documentation for details.
Using the Auto Increment Feature
The auto increment feature increments the last character
in the fiber ID you enter.
For example, if you save a test with the ID “A0”, the tester
increments the ID as follows:
A0, A1, A2…A9, A10, A11…A99, A100, A101…