Fluke DTX Series - Step 6: Running the Test

DTX Series CableAnalyzer
Technical Reference Handbook
2-18
Step 6: Running the Test
6-1 Clean the connectors on the cabling to be tested.
6-2 Make the connections as shown in Figure 2-11.
6-3 Turn the rotary switch to AUTOTEST. Verify that the
media type is set to Fiber. Press
J Change Media
to change it if necessary.
6-4 Press
P.
Tester
(End 1)
Smart remote
(End 2)
Fiber link
Patch cords
Patch cords
TALK
MONITOR
ENTER
TEST
SAVE
SPECIAL
FUNCTIONS
SETUP
AUTO
TEST
SINGLE
TEST
EXIT
F1 F2 F3
TALK
TEST
PASS
TEST
FAIL
TALK
TONE
Mandrel*
Mandrels used only for
multimode fiber
*
Mandrel*
Short patch cords
amd123f.eps
Figure 2-11. Smart Remote Mode Test Connections