Tutorials on Setup and Test Procedure
Certifying Twisted Pair Cabling 2
2-5
Step 5: Selecting a Cable ID Source
Cable IDs are names you enter for tests you save. You can
select IDs from a pre-generated list, or enter them
manually after each test. For this tutorial, you will enter
IDs manually.
To select a cable ID source:
5-1 Turn the rotary switch to SETUP.
5-2 Use D to highlight Instrument Settings; then
press
H.
5-3 Press
H to select Cable ID Source.
5-4 Use
D to highlight None; then press H.
Certifying Twisted Pair Cabling
This tutorial familiarizes you with testing twisted pair
cabling by guiding you through the following tasks:
• Attaching twisted pair adapters
• Checking the battery status and verifying operation
with twisted pair adapters
• Running an Autotest
• Viewing the Autotest results
• Saving the results
To Next Page
Loading...
