Certifying Twisted Pair Cabling
Twisted Pair Autotest Results 3
3-13
Wire Map
Wire map results show the connections between the near
and far ends of the cabling. The tester checks the cable
pairs required by the selected test limit.
If the wire map test fails, the Autotest stops and the
tester displays the wire map. You may continue the test
by pressing
L Yes.
Figure 3-8 describes examples of wire map screens.
Correct wiring (568B)
Shield continuity is shown if a shielded
(FTP or SSTP) cable type is selected in
SETUP.
Open
Wire 3 is open 61.9 m from the
tester and 22.7 m from the smart
remote.
Short
Wires 2 and 3 are shorted 3.2 ft from
the tester.
Figure 3-8. Wire Map Examples
-continued-
To Next Page
Loading...
