Fluke DTX Series - Network Connectivity Test Settings

DTX Series CableAnalyzer
Technical Reference Handbook
2-4
Step 3: Setting Up a Job Folder
You can organize test results by saving them in a folder
named for the job.
To set up a job folder:
3-1 DTX-1800, DTX-1200: Insert a memory card into the
tester.
3-2 Turn the rotary switch to SETUP.
3-3 Use
D to highlight Instrument Settings; then
press
H.
3-4 Press
D to highlight Current Folder; then press
H.
3-5 DTX-1800, DTX-1200: Press
J if necessary to select
the memory card. Typically, you should save results
on a memory card rather than in internal memory.
3-6 Press L Create Folder.
3-7 Use
JKL, BCAD, and H to
enter a folder name. Press
N when you are done.
3-8 Use
AD to highlight the new folder in the
list of folders; then press
H.
Step 4: Setting the Storage Location (DTX-1800
and DTX-1200)
To set the destination for saved results on a DTX-1800 or
DTX-1200 tester:
4-1 Turn the rotary switch to SETUP, use
D to
highlight Instrument Settings; then press
H.
4-2 Use
D to highlight Result Storage Location;
then press
H.
4-3 Use
D to highlight Internal Memory or
Memory Card (if present); then press
H.
Note
If you change storage location, and the selected
Current Folder does not exist in the new
location, the tester creates a new folder with
the current folder’s name in the new location.