Fluke DTX Series - Coaxial Test Settings

DTX Series CableAnalyzer
Technical Reference Handbook
1-26
Enabling or Disabling the Beeper
To enable or disable the tones for key presses and testing
progress:
1 Turn the rotary switch to SETUP, use
D to
highlight Instrument Settings; then press
H.
2 Press
C to go to the tab with the Audible Tone
setting. Use
D to highlight Audible Tone; then
press
H.
3 Use
D to highlight the setting you want; then
press
H.
Overview of Memory Features
All DTX testers have internal memory that can store at
least 250 Autotest results, including graphical data. The
maximum capacity of internal memory depends on the
space taken by the tester’s software.
The DTX-1800 and DTX-1200 testers can also store up to
500 Cat 6 Autotest results, including graphical data, on a
16 MB card. The testers can also use cards with higher
capacity and secure digital (SD) memory cards.
Formatting the Memory Card (DTX-1800 and
DTX-1200)
To format the memory card:
1 Insert an MMC or SD memory card into the tester, as
shown in Figure 1-11.
2 Turn the rotary switch to SPECIAL FUNCTIONS; then
select Memory Status.
3 Press
K Format; then press L Yes.
Creating Folders
You can organize your test results by saving them in
folders.
To create a folder:
1 DTX-1800, DTX-1200: Insert a memory card into the
tester.
2 Turn the rotary switch to SETUP.
3 Use
D to highlight Instrument Settings; then
press
H.
4 Press
D to highlight Current Folder; then press
H.