Fluke DTX Series - PASS*;FAIL* Results

DTX Series CableAnalyzer
Technical Reference Handbook
1-22
Checking the Hardware and Software Versions
To see version information for the tester’s hardware and
software:
1 Connect the tester and smart remote through
adapters, as in Figure 1-9.
2 Turn the rotary switch to SPECIAL FUNCTIONS.
3 Use
D to highlight Version Information; then
press
H.
4 Use
J and K to switch between the tester and
remote’s information, and between information for
the main unit and the adapters.
To determine if your tester needs a software update, visit
the Fluke Networks website to see if an update is
available.
The Main Autotest Screen
The Autotest automatically runs all the tests necessary to
certify that cabling meets the requirements of the
selected test limit. You will probably use the Autotest
more than any other of the tester’s functions.
When you first turn the rotary switch to AUTOTEST, the
main Autotest screen shows settings you should check
before you start testing. Figure 1-10 describes this screen.
You can change these settings in SETUP, as described in
Chapters 2, 3, and 5.