Fluke DTX Series - Setting the Storage Location (DTX-1800, DTX-1200); Working with Folders; Creating a New Folder

Memory Functions
Setting the Storage Location (DTX-1800, DTX-1200) 8
8-3
Setting the Storage Location (DTX-1800,
DTX-1200)
To set the destination for saved results on a DTX-1800
or DTX-1200 tester:
1 Turn the rotary switch to SETUP.
2 Use
D to highlight Instrument Settings; then
press
H.
3 Use
D to highlight Result Storage Location;
then press
H.
4 Use
D to highlight Internal Memory or
Memory Card (if present); then press
H.
Note
If you change the Result Storage Location,
and the selected Current Folder does not exist
in the new location, the tester creates a new
folder with the current folder’s name in the
new location.
Working with Folders
You can create folders for each job to organize your
test results. The tester saves test results in the folder
you select.
Creating a New Folder
To create a new folder:
1 Turn the rotary switch to SETUP.
2 Use
D to highlight Instrument Settings; then
press
H.
3 Use
D to highlight Current Folder; then press
H.
4 DTX-1800, DTX1200: Use
J to select the
location (memory card or internal memory) for
the new folder.
5 Press
L Create Folder.
6 Use the softkeys, BCAD, and H to
enter a folder name. Press
N when you are
finished.