DTX Series CableAnalyzer
Technical Reference Handbook
1-28
Push card in until
LED turns on
Inserting the card
Removing the card
Push card in to
release it
amd62f.eps
Figure 1-11. Inserting and Removing
the Memory Card
Options for Entering Cable IDs
When you save a test, you enter a name for the test. At a
job site, you usually name each test with the identification
code assigned to the link tested. You can enter this ID
character by character, or by selecting the ID from a pre-
generated list.
To select a method for entering cable IDs:
1 Turn the rotary switch to SETUP.
2 Use
D to highlight Instrument Settings, then
press
H.
3 Press
H to select Cable ID Source.
4 Use D to highlight an ID source, then press
H.
To Next Page
Loading...
