DTX Series CableAnalyzer
Technical Reference Handbook
1-16
Checking the Battery Status
The battery status icon (
) near the upper-right
corner of the tester’s main screens shows the battery’s
charge level. The smart remote’s LEDs show the smart
remote’s battery status at the end of the power-up cycle,
as shown in Figure 1-5.
To see more information about battery status:
1 On the main Autotest screen, verify that the media
type is set to Twisted Pair. Press
J Change Media
to change it if necessary.
2 Connect the tester and smart remote as shown in
Figure 1-5. You may also connect the testers through
a link.
3 Turn the rotary switch to SPECIAL FUNCTIONS.
4 Use
D to highlight Battery Status; then press
H.
The Time Remaining value tells you approximately
how long the main tester’s battery will last based on
the last 3 minutes of use.
The accuracy of the battery gauge may drift over time. If
the battery status information seems incorrect, reset the
battery gauge as described in Chapter 9.
To Next Page
Loading...
