Fluke DTX Series - Typical Measurement Accuracy

Maintenance and Specifications
Specifications 9
9-21
Typical Measurement Accuracy
The typical measurement accuracy of the DTX Series
CableAnalyzer testers meets or exceeds accuracy Level IV.
The DTX-1800 measures up to 900 MHz and is fully
compliant with accuracy Level IV. The DTX-1200 and
DTX-LT measure up to 350 MHz with accuracy Level IV
performance.
The following typical accuracy performance parameters
are used for asterisk (*) results reporting. These are based
on computation of the overall measurement accuracy
based on the worst case of each parameter at each
frequency data point. Observed differences between
laboratory equipment and DTX CableAnalyzers using
calibration verification artifacts were used as a
confirmation.
Accuracies computed from the parameters in Table 9-3
are shown in Figures 9-3 through 9-6.