DTX Series CableAnalyzer
Technical Reference Handbook
2-2
Step 2: Entering Job Information
Job information includes the operator name, name of
the job site, and the customer’s company name. These
settings are stored with results you save.
To enter job information:
2-1 Turn the rotary switch to SETUP.
2-2 Use
D to highlight Instrument Settings; then
press
H.
2-3 Press
C to go to the tab with the Operator Name
setting. Press
H to select Operator Name.
2-4 Use JKL, BCAD, and H to
enter your name in the box. Press
N when you are
done.
2-5 Figure 2-1 describes the text editing screen.
2-6 Use
D to highlight Site; then press H.
2-7 Use JKL, BCAD, and H to
enter the job site name in the box. Press
N when
you are done.
2-8 Repeat steps 2-6 and 2-7 to enter the customer’s
Company name.
To Next Page
Loading...
