Fluke DTX Series - Sorting Results; Formatting a Memory Card (DTX-1800, DTX-1200)

DTX-Series CableAnalyzer
Technical Reference Handbook
8-8
Sorting Results
You can sort the list of saved results in ascending or
descending order by the following parameters:
• PASS/FAIL result
• Cable ID
• Date and time the test was completed
To sort results:
1 On the View Results screen, press
L Sort.
2 Use
D to highlight the field you want to sort
by.
3 Press
J Ascending or L Descending.
The sorting order applies only to the current folder.
The current sorting order is indicated at the top of the
View Results screen, as shown in Figure 8-2 on page
8-6
The default order is ascending by cable ID. The sorting
order reverts to the default when you leave the
SPECIAL FUNCTIONS mode, turn off the tester, or
upload the results to a PC.
Formatting a Memory Card (DTX-1800,
DTX-1200)
To format a memory card:
1 Insert the card into the slot on the left side of the
tester.
2 Turn the rotary switch to Autotest
3 Press
L Memory.
4 Press K Format; then press L Yes.
You can also format a memory card in SPECIAL
FUNCTIONS mode:
1 Turn the rotary switch to SPECIAL FUNCTIONS.
2 Use
D to highlight Memory Status; then
press
H.
3 Press
K Format; then press L Yes.